Mike

Mike

26 followers
·
27 followers
Mike
More ideas from Mike
If you have an interest in Japanese joinery or joinery in general, then I would like to point you to an article series by John Bullar.  Mr. Bullar is writing this article series about Japanese join…

If you have an interest in Japanese joinery or joinery in general, then I would like to point you to an article series by John Bullar. Mr. Bullar is writing this article series about Japanese join…

Cut with a Drill If you need to shorten a bolt, let your drill do the hard work. Spin two nuts onto the bolt, tightening them against each other. Then chuck the bolt into the drill and hold a hacksaw blade against the spinning bolt. The nuts help to steady the blade and clean off burrs when you unscrew them.

Spin two nuts onto the bolt, tightening them against each other. Then chuck the bolt into the drill and hold a hacksaw blade against the spinning bolt. The nuts help to steady the blade and clean off burrs when you unscrew them.

Tenon-Cutting Sled

Tenon-Cutting Sled