More ideas from gary
Need to add a little bit of detail to your work?  Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel.  These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish.  Dimensions are 1.5" diameter by approximately 1" combined height.   Each one of these dies have been tested on 22, 20, and 18ga mild steel…

Need to add a little bit of detail to your work? Drill or punch a 3/8" hole where you would like this detail then use either an impact hammer (air or cordless) or a hydraulic press to drive these dies together and form a unique "Crater" in your panel. These dimple dies are made from 4140 alloy steel and then hardened and tumbled for a smooth finish. Dimensions are 1.5" diameter by approximately 1" combined height. Each one of these dies have been tested on 22, 20, and 18ga mild steel…