More ideas from Des
A good technique for straightening a board on a table saw is to attach it to a straight board and then rip it.

A good technique for straightening a board on a table saw is to attach it to a straight board and then rip it.

Cutting thin strips. To make the jig, attach a 5-in.-long strip of wood, 1/16 in. narrower than the width of the desired rip, to the end of a 1x6 as shown. Basically you're creating a horizontal push stick. Add a handle near the end of the jig to give yourself better control as you run the jig through the saw.

Cutting thin strips. To make the jig, attach a 5-in.-long strip of wood, 1/16 in. narrower than the width of the desired rip, to the end of a 1x6 as shown. Basically you're creating a horizontal push stick. Add a handle near the end of the jig to give yourself better control as you run the jig through the saw.

Auto a pedales hecho con material reciclado! - Bueno, siguiendo con la descripción este auto a pedales tiene tracción en una sola rueda, lo que lo hace liviano para moverlo y estable a la hora de tomar curvas cerradas, se trata de un eje de acero de 1/2 pulgada de diámetro y 50 cms de largo, que vá montado en dos descansos, (porta rodamientos, chumaceras)

Auto a pedales hecho con material reciclado! - Bueno, siguiendo con la descripción este auto a pedales tiene tracción en una sola rueda, lo que lo hace liviano para moverlo y estable a la hora de tomar curvas cerradas, se trata de un eje de acero de 1/2 pulgada de diámetro y 50 cms de largo, que vá montado en dos descansos, (porta rodamientos, chumaceras)