Beverley Mather

6 followers
·
0 following
Beverley Mather
More ideas from Beverley
Boley lathe accessories

Boley lathe accessories

- Tool spindle ER20, concentric accuracy in the whole system less than 0.01mm - Stepper Nanotec NEMA 17, ST4118L-3004, 3A, 0.5Nm, 1.

- Tool spindle concentric accuracy in the whole system less than - Stepper Nanotec NEMA

Tailstock Alignment. by tonyfoale - There are two usual methods to align a lathe tailstock.1. Put a bar between centres and take a cut along its length, measure each end, adjust tailstock and repeat procedure until it is within acceptable limits. This is time consuming and you reduce your bar to swarf.2. Get a standard ground alignment bar made for the purpose. Mount it and traverse its length with an indicator. Adjust tailstock to suit. This can be much quicker than method 1. but you nee

There are two usual methods to align a lathe tailstock. Put a bar between centres and take a cut along its length, measure each end, adjust